Doug Fleenor Design 121Q DMX Isolation Amplifier and Splitter, 4 Universe, 1-Input, 1-Output - TERMINAL BLOCK

For the receiving end of long control runs the DMX512 Isolation Amplifier is recommended.

It contains separate input and output power supplies.

This allows the input circuitry to receive signals as low as 0.2 volts.

These are optionally available in any number of configurations for systems with more than one DMX512 universe.

Input and output circuitry and specifications are identical to that of DFD's standard splitters.The model 121D and 121Q contain the same isolation and protection circuitry used in the 121, but have multiple isolators in a single enclosure.

They are ideally suited for use with control consoles which have multiple DMX outputs.

The model 121D has two isolators and the 121Q has four isolators.Doug Fleenor Designs 121Q Specifications:Input circuit: EIA-485 receiver with 120 ohmTermination resistor between +Data and -Data (Units with optional feed throughconnectors do not have internal termination)Input signal: 0.2 volts minimum, 12 voltsmaximumOutput circuit: EIA-485 driverConnectors: Gold plated 5 pin Neutrik D-1Series (3 pin connectors or terminal blocks optional)Feed through: A non-isolated feed throughconnector is optionalIsolation: 2500 volt optical coupler, 1500 voltage split bobbin transformerPower input: 100 - 120 volts, 50/60 hertz, 12 watts (208 - 240 volt optional)Color: Top, bottom and sides: Silver hammertoneFront and back: BlackSize (DxHxW): 121Q 6.5" x 1.7" x 16", Doug Fleenor Design 121Q DMX Isolation Amplifier and Splitter, 4 Universe, 1-Input, 1-Output - TERMINAL BLOCK.