Doug Fleenor Design 221E DMX Combine Unit, 2-Inputs, 1-Output - TERMINAL BLOCK

The DMX512 Combine unit solves the problem of combining multiple DMX input signals into a single DMX output signal.

The most common configuration of the unit allows two consoles to control a single set of dimmers in a highest takes precedence or pile on mode.

Examples of where this might be necessary include booth console/stage manager's console, primary console/backup console, and where one console controls intensity of a moving light fixture while a second console is used for color and/or position.Units with up to six inputs are available.

More than six inputs can be accommodated using a Primary/Secondary arrangement.

Units that patch and/or route the DMX dimmer channels are available for applications where two consoles control a single dimmer rack with loads in separate rooms.

Such units prevent the operator in room 'A' from bringing up the lights in room 'B'.Doug Fleenor Designs 221E Specifications:Baud rate: 250 Kilo baudInput circuit: EIA-485 receiver with 120 ohm termination between +data and -dataInput connectors: Gold plated 5 pin male (Neutrik D1 series) Terminal Block OptionalOutput circuit: EIA-485 driverOutput connector: Gold plated 5 pin female (NeutrikD1 series) Terminal Block OptionalInput to output delay: 1/100 second average 1/50second maximumPower input: 100 - 120 volts, 50/60 hertz, 12 watts(208 - 240 volt optional)Power cord: Attached 5' 18/3 cord with parallel blade with ground plug.Color: Silver hammertone with black front and back panels.Size (DxHxW): 11.25", "color": "Silver hammertone with black front and back panels.", "dimensions": "Size (DxHxW): 11.25", 1.74", 8.25"", "weight": "4.9 pounds", "keywords": ["DMX512", "Combine unit", "Fleenor Designs", "221E", "Neutrik D1series", "Terminal Block"]}