6'' Setback Jack Plates for Outboard Motor Manual Add Distance Between Engine and Transom

Performance of your boat Manual Jack Plates is rated for motors up to 150 hp and comes in an attractive polished aluminum finish.

Fits all V-4 and V-6 standard bolt pattern engines.

Some special drilling of holes may be required on engines manufactured before 1980.

Long shaft engines with a short shaft transom! Two pairs of precision machined aluminum angles locate the motor with 6 inch setback from the transom.The engine side holes of the Jack Plate is drilled 1.500 inches higher than the transom side.

Combined with the 4 inches of adjustable vertical lift you can obtain 5.500 inches at a maximum height Here are the pre-drilled hole dimensions listed below in inches: This Jack Plate for outboard motor is rated for motors up to 150 hp and comes in an attractive polished aluminum finish.