WHDZ 86PCS Paintless Dent Repair Tool Paintless dent repair Rods Kit with Slider Hammer Dent Lifter Bridge Puller Set LED Line Board for Pop a Dent

Description How to use? 1.

Clean the dent with a clean wet cloth; 2.

Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; 3.

Glue a Tab with hot melt glue: - Use Lifter or T- shapred repairer : Glue a Pulling Tab with hot melt glue on it’ s back by glue gun tool; - Use Bridge Puller: Glue the middle tab of Bridge Puller set with hot melt glue on it‘ s back by glue gun tool; 4.

Put the Tab with hot melt glue at the center of dent fast, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes.

The cooling time should be less than 10 minutes and should be shorter slightly in winter).

5.

Pull out tabs: - Use Lifter: Screw the rotary axis of the Lifter to find a perfect range for the spring which can pull the tab out.

Then press the handle to pull out the tabs directly; - Use Bridge Puller: Adjust the three screws’ height to find a perfect place for the Bridge Puller, then pull out the tabs directly; - Use Slide Hammer repairer: Align the T- shapred repairer and press the drawing tabs with hot melt glue, pull the sliding rod backwards to pull up the dent; 6.

Check with a Line board.

If dent still exists, knock it slightly with a flattening hammer or pen; 7.

Use the plastic shovel to remove the glue stuck on the machine body.

And then clean the repaired place with a clean wet cloth.