Hanson 12 Pc. Taps & Dies Carded Set

from johnval

The tap wrench chuck will not tighten down to hold the 6-32 and 8-32 taps. Fortunately I had a separate wrench that could and was able to complete the job. This set doesn't work as packaged.

from Buck Steele

The Tap handle won't squeeze small enough to hold the #6 tap. After three uses, the thread slip on the tap handle collet so it won't even hold the #8 tap!

from RedRedWine

I just purchased the same 12-piece set in metric. Its smallest size tap is 3mm-0.50 and the tap holder will not even come close to gripping that tap's square base to drive it. The 2nd smallest ta...

from NHRich

It's hard to imagine a company, that claims to manufacture precision tools, could sell a tool set that, "by all appearances", has never even been tested (let alone looked at) before release to the ...

from Bubba dub

I bought the metric for use on rc hobby vehciles mainly needing the smaller two taps and dies. As long as you are using them in soft metals they are ok, anything harder than brass or aluminum they ...