SharkBite 1/2 PTF x 3/8 Compression Chrome Plated Angle Stop Valve

from Kyle B

[This review was collected as part of a promotion.] I've been using these stops a couple years now. So far not one has leaked and you only need an inch of pipe stub to install! Whether its PEX, Cu, CPVC or even PB these stops can be used. Cut the old stop off, ensure the pipe is burr free and sli...

from Kathie B

[This review was collected as part of a promotion.] We bought this in preparation for installing a laundry room sink. We were both skeptical of the ease of installation. But, after cutting our pipes square, making sure the pipes were squeaky clean, installation took about 5 minutes. NO LEAKS! We'...

from Gerald K

Pushed on the fresh cut copper pipe under the sink. No problems at all and it took only a few minutes. Bought it at Ace Hardware.

from Julie A

I have purchase shark bite valves and couplings in the past to make transitions between our cpvc pipe and new pipe or new fixture lines. We got a valve last weekend that must have a small crack in a seam. It was impossible for me to remove to replace because of its position in front of a wall. Ha...

from DerekC

I have used SharkBite in the past with no concerns, but I installed a angle valve to install for the toilet. I am starting to notice it is now dripping just below the nut to the toilet hose. I may try another one to see if I got faulty one.