VEVORbrand Dividing Head BS-0 5Inch 3 Jaw Chuck Dividing Head Set Precision Semi Universal Dividing Head for Milling Machine Rotary Table Tailstock Milling Set

from Richard V. Lando II

I haven't actually used this for anything yet. I did however disassemble and check everything. Initial run-out was 7-10 thousandths and I was disappointed. I then installed the dead center and checked run-out and it was .0005 in. OK. that is great! I then re-installed the chuck and chucked in som...

from scrugs

This unit went into a shop that supports both a museum and a low volume commercial small job shop, so I did not expect to be doing divider work very often. However, I have found it to be very versital and its low profile makes it easy to add to the BP table along side the mill vise. My only compl...

from Kevin Lloyd

originally i needed a new chuck for my lathe so while shopping i came across the dividing head. my chuck would have been over 1/2 cost of entire dividing head. secondly first day here it was put to work dividing! works great nice piece for my retirement shop

from Timothy B. Rhyne

This is a very nice dividing head for the money. Pretty well finished and smooth operating, very little lash in the gearing.If you were thinking to use an ER32 chuck in the headstock taper note that the taper is #2 Morse not #7B&S as stated in the specifications. That is really good news given th...

from bowcoastie

This dividing head has been fantastic. It is very durable and exceedingly accurate. It fights with my vise for space on the milling machine and often wins. There are so many projects that I can get done in far shorter time than I was able to before buying this. I am so grateful to have added this...