CONFAST 5/8" Lag Shield Anchor Long (25 per Box): Industrial & Scientific

The anchor is made from Zamac Alloy.

This anchor is designed for use in Concrete, Block, and Brick.

Environment The anchor is designed for use in a Wet environment.

Hole Diameter/Bit Diameter The anchor requires a 7/8" hole to be drilled in the base material (Concrete, Block, and Brick).

The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Minimum Embedment The minimum anchor embedment into the concrete is 3-1/2".

Therefore, the anchor must be installed so that a minimum of 3-1/2" of the anchor is embedded into the concrete.

Spacing between Anchors Each anchor must be spaced a minimum distance of 8-3/4" from each other when measured center to center.

Edge Distance It is very important not to install the anchor any closer than 4-3/8" from an unsupported edge of the concrete.

Features & details Features ANCHOR IS MADE FROM RUST RESISTANT MATERIAL-Can be used in areas where moisture is present if the bolt used is rust resistant BOLT EXPANDS ANCHOR-No setting tool required; fast and easy WORKS IN MOST MASONRY MATERIAL-Versatile for wide range of applications LAG SCREWS MUST BE USED-Easy to find many lengths and diameters.