Hanson 1/4" Quick Change Bit Holder 12" Length

from Mike The Plumber

I have used lots of these over the years and almost all of them had the same problem, The bit gets stuck in them because the lock wont disengage (Very Frustrating).

from

I have a 2" and 12" unit. They are nice in that they will take an insert tip as well as the ball detent tip holder, but the first 12" one locked exactly twice and then failed to hold anything, I g...

from daniel

i do old work electrical work residential and the paddle bits does little bamage to pipes bx cables and such item and the exstention bits get in a lot of difficult places [This review was collected...

from Crib Master

Bought about 6 of these over several years - using them in industrial setting - and have held up fine. Making this review due to the number of people complaining about them - & I've had no trou...

from Just a guy

Take all of the tape off and expose the plastic packaging. Tool rests in holder that pivots on back and low. Holder pivots and swings down and out. Only use hex not a round bit with a three jaw...